9 PSTatistic Subsystem
326 N1911A/1912A P-Series Power Meters Programming Guide
PSTatistic:CCDF:MARKer[1]|2:X <numeric_value>
This command is used to set the current marker X-axis position at the selected
trace.
Syntax
Parameters
[a] The marker will be placed at the point nearest to the specified X-axis position if that particular X value is not available.
This command is only applicable when P-Series sensors are present and the
following conditions are met:
– Free-run acquisition mode is selected
– NORMal or DOUBle measurement speed setting is chosen
– Expanded window is enabled (not full CCDF screen window)
PST
:CCDF
2
: X
1
:MARK
Space
numeric_value
Item Description/Default Range of Values
numeric_value
The current marker X-axis position
[a]
.
– Maximum Value: 50 dB. The value will be set to 0 if negative
value is inserted.
<
50
To Next Page
Loading...
