SENSe Subsystem 10
N1911A/1912A P-Series Power Meters Programming Guide 427
[SENSe[1]]|SENSe2:MRATe <character_data>
This command sets the measurement speed on the selected channel.
When a channel is set to FAST, the following couplings occur:
[a] This change only occurs on the channel specified in the SENSe:MRATe command. When the specified channel is changed from FAST to
NORMal or DOUBle, the settings that were in place when FAST was entered are restored.
[b] This change occurs when either channel is set to FAST. When both channels are changed from FAST to NORMal or DOUBle, the settings
that were in place when FAST was entered are restored.
[c] Applicable to the N1912A dual channel power meter only.
Command Status
[SENSe[1]]|SENSe2:AVERage:STATe
OFF
[a]
[SENSe[1]]|SENSe2:CORRection:DCYCle:STATe
OFF
[a]
[SENSe[1]]|SENSe2:CORRection:GAIN2:STATe
OFF
[a]
CALCulate[1|2|3|4]:GAIN:STATe
OFF
[b]
CALCulate[1|2|3|4]:RELative:STATe
OFF
[b]
CALCulate1|3:MATH:EXPRession “(SENSe1)”
CALCulate2|4:MATH:EXPRession
“(SENSe2)”
[c]
To Next Page
Loading...
Need help?
General
