9 PSTatistic Subsystem
338 N1911A/1912A P-Series Power Meters Programming Guide
PSTatistic:CCDF:REFerence:POWer:PTAVerage?
This command is used to retrieve peak to average data of the saved reference
trace.
Syntax
Example
Error Messages
– If command is executed in other window besides CCDF window, error –221
"Settings conflict: Requires CCDF window" occurs.
– If there was no previously saved trace, error –221 "Settings conflict: No
reference trace saved" occurs. Please check the status of saved reference trace
using command PST:CCDF:STOR:REF?.
This command is only applicable when P-Series sensors are present and the
following conditions are met:
– Free-run acquisition mode is selected
– NORMal or DOUBle measurement speed setting is chosen
PST:CCDF:REF:POW:PTAV?
This command returns the peak to average
power of the saved reference trace.
To Next Page
Loading...
