5 DISPlay Subsystem
258 N1911A/1912A P-Series Power Meters Programming Guide
DISPlay[:WINDow[1]|2]:TRACe:FEED <character_data>
This command selects which channel’s trace is displayed in the specified window.
Syntax
Parameters
Example
Reset Condition
On reset, the value is set to:
– Upper window: SENS1
– Lower window (dual channel only): SENS2
Item Description/Default Range of Values
character_data Identifies which channel’s trace is displayed.
– SENS1: Channel A
– SENS2: Channel B
“SENS1”
“SENS2”
DISP:WIND2:TRAC:FEED “SENS1” This command selects Channel A’s trace to
be displayed in the lower window.
:WIND
1
2
:TRAC
Space
character_data
DISP
:FEED
To Next Page
Loading...
