1 Power Meter Remote Operation
96 N1911A/1912A P-Series Power Meters Programming Guide
Using “*” Commands
Commands starting with a “*” are called common commands. They are required
to perform the identical function for all instruments that are compliant with the
IEEE-488.2 interface standard. The “*” commands are used to control reset,
self-test, and status operations in the power meter.
Syntax Conventions
Throughout this guide, the following conventions are used for SCPI command
syntax.
– Square brackets ([]) indicate optional keywords or parameters.
– Braces ({}) enclose one or more parameters that may be included zero or more
times.
– Triangle brackets (<>) indicate that you must substitute a value for the
enclosed parameter.
– Bars (|) can be read as “or” and are used to separate alternative parameter
options.
Syntax Diagram Conventions
– Solid lines represent the recommended path.
– Ovals enclose command mnemonics. The command mnemonic must be
entered exactly as shown.
– Dotted lines indicate an optional path for by passing secondary keywords.
– Arrows and curved intersections indicate command path direction.
To Next Page
Loading...
