Keysight N1911A

12 SYSTem Subsystem
592 N1911A/1912A P-Series Power Meters Programming Guide
[a] The Range setting in Table 12-50 is only applicable for E-Series power sensor and N8480 Series power sensor (excluding Option CFT).
Table 12-51 WiMAX: Power Meter Presets: Window/Measurement Settings
TRIG[:SEQ]:DEL 0 s Delay between recognition of trigger event
and start of a measurement
TRIG[:SEQ]:HOLD 4 ms Trigger holdoff
Range
[a]
[SENS[1]]|SENS2:POW:AC:RANG:AUTO OFF Auto range off
[SENS[1]]|SENS2:POW:AC:RANG UPPER Range set to upper
Step detection
[SENSe[1]]|SENS2:AVER:SDET 0 Step detection disabled
Trace setup
[SENS[1]]|SENS2:TRAC:OFFS
:TIME <numeric_value>
-0.2 ms Delay between delayed trigger point and
the start of the trace
[SENS[1]]|SENS2:TRAC:TIME
<numeric_value>
3 ms Length of the trace
Function Setting
Single Channel Dual Channel
Display setup
Upper window Dual numeric See Table 12-52
Lower window Dual numeric See Table 12-52
Window/measurement setup
Upper window/upper measurement (UU)
Feed Gate 1 Channel A
Gate 1 primary channel
[a]
Measurement Avg Avg
Upper window/lower measurement (UL)
Feed Gate 1 Channel A See Table 12-52
Measurement Pk-to-Avg See Table 12-52
Command Setting Comments