9 PSTatistic Subsystem
330 N1911A/1912A P-Series Power Meters Programming Guide
PSTatistic:CCDF:REFerence:DATa?
This command is used to retrieve the reference trace data and it is independent of
the channel attached. The reference trace data will be returned only if there is a
reference trace saved.
Syntax
Example
Reset Condition
On reset, the trace will be cleared.
This command is only applicable when P-Series sensors are present and the
following conditions are met:
– Free-run acquisition mode is selected
– NORMal or DOUBle measurement speed setting is chosen
The reference trace data returned in the format as shown below:
– The reference trace data maximum X-axis value in dB
– 501 points of the reference trace data
PST:CCDF:REF:DAT? This command returns the previously saved
reference trace data.
To Next Page
Loading...
