N1911A/1912A P-Series Power Meters
Programming Guide
303
8 OUTPut Subsystem
OUTPut Subsystem 304
OUTPut:RECorder[1]|2:FEED <data_handle> 305
OUTPut:RECorder[1]|2:LIMit:LOWer <numeric_value> 307
OUTPut:RECorder[1]|2:LIMit:UPPer <numeric_value> 309
OUTPut:RECorder[1]|2:STATe <boolean> 311
OUTPut:ROSCillator[:STATe] <boolean> 312
OUTPut:TRIGger[:STATe] <boolean> 313
This chapter explains how the OUTput command subsystem is used to switch the
POWER REF output on and off.
To Next Page
Loading...
