TRIGger Subsystem 14
N1911A/1912A P-Series Power Meters Programming Guide 657
TRIGger[1]|2:SOURce
BUS|EXTernal|HOLD|IMMediate|INTernal[[1]|2]
This command configures the trigger system to respond to the specified source.
This command only selects the trigger source. Use the INITiate command to
place the power meter in the wait for trigger state.
Syntax
– This command has been included for compatibility purposes. It has the same
purpose as TRIGger[:SEQuence[1]|2]:SOURce
BUS|EXTernal|HOLD|IMMediate|INTernal[[1]|2] which should be used
in preference.
– If the source is set to INT, INT1 or INT2 when connecting the N1920 or E9320
sensor in average mode, errors occurs.
TRIG
:SOUR
1
2
BUS
EXT
Space
HOLD
IMM
INT
1
2
?
To Next Page
Loading...
