15 SERVice Subsystem
710 N1911A/1912A P-Series Power Meters Programming Guide
SERVice:SENSor[1]|2:CPLace?
This query returns the calibration place in P-Series, E-Series sensors and N8480
Series sensors. Calibration place information is stored in the sensor’s EEPROM.
Syntax
Example
Error Messages
– If no power sensor is connected, error –241 “Hardware missing” occurs.
– If a sensor other than a P-Series, N8480 Series or E-Series power sensor is
connected, error –241 “Hardware missing” occurs.
SERV:SENS2:CPL? This query returns the place of calibration of
the P-Series, E-Series sensor or N8480
Series sensor connected to Channel B.
To Next Page
Loading...
