7 MEMory Subsystem
276 N1911A/1912A P-Series Power Meters Programming Guide
MEMory:CLEar Commands
These commands are used to remove the contents stored in the sensor calibration
tables (8480 Series sensors and N8480 Series sensors with Option CFT only),
frequency dependent offset tables and save/recall registers. This subsystem
removes the data contents but does not affect the name of the associated table or
save/recall register.
The following commands are detailed in this section:
MEMory:CLEar:[NAME] <character_data>
MEMory:CLEar:TABLe
The contents cleared using these commands are non-recoverable.
To Next Page
Loading...
