Keysight N1911A

5 DISPlay Subsystem
256 N1911A/1912A P-Series Power Meters Programming Guide
DISPlay[:WINDow[1]|2]:STATe <boolean>
This command enables/disables the upper or lower window (WINDow1 and
WINDow2 respectively) so that the display shows a single window only. The
displayed window is presented in expanded format, showing a single
measurement only: either the single measurement that was shown on the window,
or the currently selected measurement, if two measurements had been shown.
Syntax
Examples
Reset Condition
On reset, both windows are enabled.
DISP:WIND2:STAT OFF This command disables the lower window.
The upper window in shown in expanded
format, displaying its currently selected
measurement.
DISP:WIND2:STAT ON This command enables the lower window so
that a dual window display is once more
provided.
:STAT
0|OFF
1|ON
Space
?
:WIND
1
2
DISP