10 SENSe Subsystem
380 N1911A/1912A P-Series Power Meters Programming Guide
[SENSe[1]]|SENSe2:AVERage2 Commands
These commands control video averaging, which is used to improve measurement
accuracy, for the P-Series and E-Series E9320 power sensor. They combine
successive measurements to produce a new composite result.
The following commands are detailed in this section:
[SENSe[1]]|SENSe2:AVERage2:COUNt <numeric_value>
[SENSe[1]]|SENSe2:AVERage2[:STATe] <boolean>
If the command is used when a sensor other than a P-Series or E9320 power
sensor is connected, error –241, “Hardware missing” occurs.
If the commands in this section are used when an E9320 sensor is connected
and set to AVERage mode rather than NORMal mode, the error –221, “Settings
Conflict” occurs.
To Next Page
Loading...
