Keysight N1911A

12 SYSTem Subsystem
500 N1911A/1912A P-Series Power Meters Programming Guide
SYSTem:COMMunicate:LAN:CURRent:DNAMe?
This command returns the current setting of the LAN domain name in use by the
power meter.
Syntax
Example
NOTE
If DHCP or AutoIP are successfully enabled, then one of these IP address modes
assign the LAN domain name, otherwise it is the static LAN domain name.
SYST
:COMM
:CURR
:DNAM
?
:LAN
SYST:COMM:LAN:CURR:DNAM? This command queries the current setting of
the LAN domain name.