TRIGger Subsystem 14
N1911A/1912A P-Series Power Meters Programming Guide 677
TRIGger[:SEQuence[1]|2]:SOURce
BUS|EXTernal|HOLD|IMMediate|INTernal[[1]|2]
This command configures the trigger system to respond to the specified source.
This command only selects the trigger source. Use the INITiate command to
place the power meter in the wait for trigger state.
Syntax
This command has the same purpose as TRIGger[1]|2:SOURce
BUS|EXTernal|HOLD|IMMediate|INTernal[[1]|2].
:SOUR
TRIG
:SEQ
1
2
BUS
EXT
Space
HOLD
IMM
INT
1
2
?
To Next Page
Loading...
