PSTatistic Subsystem 9
N1911A/1912A P-Series Power Meters Programming Guide 325
PSTatistic:CCDF:MARKer[1]|2:DATa?
This command is used to retrieve the power and probability values at the current
marker position at any trace the marker is positioned.
Syntax
Example
Reset Condition
On reset, the marker 1 and marker 2 will be set back to their default positions.
Error Messages
– If command is executed in other window besides CCDF window, error –221
“Settings conflict: Requires CCDF window” occurs.
This command is only applicable when P-Series sensors are present and the
following conditions are met:
– Free-run acquisition mode is selected
– NORMal or DOUBle measurement speed setting is chosen
PST:CCDF:MARK1:DAT? This command returns the power and
probability values at marker 1.
To Next Page
Loading...
