STATus Subsystem 11
N1911A/1912A P-Series Power Meters Programming Guide 475
Operation Register Sets
The following registers contain information which is part of the power meter’s
normal operation. The contents of the individual registers of these register sets
may be accessed by appending the commands listed in Status Register Set
Commands.
The following command descriptions detail the SCPI register you require to
control but do not detail the Register Set commands.
The seven Operation Register Sets are:
STATUS:OPERation
STATus:OPERation:CALibrating[:SUMMary]
STATus:OPERation:LLFail[:SUMMary]
STATus:OPERation:MEASuring[:SUMMary]
STATus:OPERation:SENSe[:SUMMary]
STATus:OPERation:TRIGger[:SUMMary]
STATus:OPERation:ULFail[:SUMMary]
Further information on these register sets is provided on the following pages.
To Next Page
Loading...
