8 OUTPut Subsystem
304 N1911A/1912A P-Series Power Meters Programming Guide
OUTPut Subsystem
The OUTPut command subsystem is used to control the trigger output, switch on
and off the POWER REF output, and controls the recorder output.
Keyword Parameter Form Notes Page
OUTPut
:RECorder[1]|2
:FEED <data_handle> page 305
:LIMit
:LOWer <numeric_value> page 307
:UPPer <numeric_value> page 309
:STATe <boolean> page 311
:ROSCillator
[:STATe] <boolean> page 312
:TRIGger
[:STATe] <boolean> page 313
To Next Page
Loading...
