N1911A/1912A P-Series Power Meters
Programming Guide
639
14 TRIGger Subsystem
TRIGger Subsystem 640
ABORt[1]|2] 642
INITiate Commands 643
INITiate[1]|2:CONTinuous <boolean> 644
INITiate[1]|2[:IMMediate] 646
INITiate:CONTinuous:ALL <boolean> 647
INITiate:CONTinuous:SEQuence[1]|2 <boolean> 649
INITiate[:IMMediate]:ALL 651
INITiate[:IMMediate]:SEQuence[1]|2 652
TRIGger Commands 653
TRIGger[1]|2:DELay:AUTO <boolean> 654
TRIGger[1]|2[:IMMediate] 656
TRIGger[1]|2:SOURce BUS|EXTernal|HOLD|IMMediate|INTernal[[1]|2] 657
TRIGger[:SEQuence]:DELay <numeric_value> 660
TRIGger[:SEQuence]:HOLDoff <numeric_value> 662
TRIGger[:SEQuence]:HYSTeresis <numeric_value> 664
TRIGger[:SEQuence]:LEVel <numeric_value> 666
TRIGger[:SEQuence]:LEVel:AUTO <boolean> 668
TRIGger[:SEQuence]:SLOPe <character_data> 670
TRIGger[:SEQuence[1]|2]:COUNt <numeric_value> 672
TRIGger[:SEQuence[1]|2]:DELay:AUTO <boolean> 674
TRIGger[:SEQuence[1]|2]:IMMediate 676
TRIGger[:SEQuence[1]|2]:SOURce
BUS|EXTernal|HOLD|IMMediate|INTernal[[1]|2] 677
This chapter explains how the TRIGger command subsystem is used to
synchronize device actions with events.
To Next Page
Loading...
