PSTatistic Subsystem 9
N1911A/1912A P-Series Power Meters Programming Guide 321
PSTatistic:CCDF:GAUSsian:MARKer[1]|2[:SET]
This command is used to set the markers on Gaussian trace. The markers will be
set only if the trace is present and visible. According to the selections made, the
markers will become active on the screen.
Syntax
Example
Reset Condition
On reset, the marker is set on the next visible trace according to the sequence
Channel A, Channel B, Reference or Gaussian.
This command is only applicable when P-Series sensors are present and the
following conditions are met:
– Free-run acquisition mode is selected
– NORMal or DOUBle measurement speed setting is chosen
– Expanded window is enabled (not full CCDF screen window)
:MARK
PST
:CCDF :GAUS
:SET
2
1
PST:CCDF:GAUS:MARK This command sets marker 1 on the
Gaussian trace.
To Next Page
Loading...
