Keysight N1911A

7 MEMory Subsystem
270 N1911A/1912A P-Series Power Meters Programming Guide
MEMory:CATalog Commands
These commands are used to query information on the current contents of a
power meter’s:
– Sensor calibration tables (8480 Series sensors and N8480 Series sensors with
Option CFT only)
– Frequency dependent offset tables
– Save/recall registers
The following commands are detailed in this section:
MEMory:CATalog[:ALL]?
MEMory:CATalog:STATe?
MEMory:CATalog:TABLe?