TRIGger Subsystem 14
N1911A/1912A P-Series Power Meters Programming Guide 653
TRIGger Commands
TRIGger commands control the behavior of the trigger system.
The following commands are described in this section:
TRIGger[1]|2:DELay:AUTO <boolean>
TRIGger[1]|2:SOURce BUS|IMMediate|HOLD
TRIGger[1]|2[:IMMediate]
TRIGger[:SEQuence]:DELay <numeric_value>
TRIGger[:SEQuence]:HOLDoff <numeric_value>
TRIGger[:SEQuence]:HYSTeresis <numeric_value>
TRIGger[:SEQuence]:LEVel <numeric_value>
TRIGger[:SEQuence]:LEVel:AUTO <boolean>
TRIGger[:SEQuence]:SLOPe <character_data>
TRIGger[:SEQuence[1]|2]:COUNt <numeric_value>
TRIGger[:SEQuence[1]|2]:DELay:AUTO <boolean>
TRIGger[:SEQuence[1]|2]:IMMediate
TRIGger[:SEQuence[1]|2]:SOURce
BUS|EXTernal|HOLD|IMMediate|INTernal[[1]|2
To Next Page
Loading...
