14 TRIGger Subsystem
642 N1911A/1912A P-Series Power Meters Programming Guide
ABORt[1]|2]
This command removes the specified channel from the wait for trigger state and
places it in the idle state. It does not affect any other settings of the trigger
system. When the INITiate command is sent, the trigger system responds as it
did before ABORt was executed.
If INITiate:CONTinuous is ON, then after ABORt the specified channel
immediately goes into the wait for trigger state.
Syntax
Example
ABOR This command places Channel A in the idle
state.
To Next Page
Loading...
