Power Meter Remote Operation 1
N1911A/1912A P-Series Power Meters Programming Guide 31
The character_data values for the IP address, Subnet Mask, and Default
Gateway can range between 0.0.0.0 and 255.255.255.255.
The LAN setting values are stored in non-volatile memory and are not part of the
save-recall function.
USB Configuration
The USB interface requires no front panel or remote configuration.
The USB address cannot be changed - it is set at the factory and is unique for
each power meter.
If you configure an invalid IP Address or an IP address that is used by another
device or host, an error message is generated. This error can be read by using
the SYSTem:ERRor? command.
For further information about the USB configuration refer to the P-Series Power
Meters Installation Guide.
Before connecting the USB cable, make sure that I/O software is installed on
your computer.
For more information about Keysight IO Libraries software refer to the
Connectivity Guide.
If you have installed other I/O Software, refer to documentation that
accompanies the software.
To Next Page
Loading...
