Keysight N1911A

14 TRIGger Subsystem
662 N1911A/1912A P-Series Power Meters Programming Guide
TRIGger[:SEQuence]:HOLDoff <numeric_value>
This command sets the trigger holdoff in seconds.
Syntax
Parameters
Item Description/Default Range of Values
numeric_value The trigger holdoff in seconds.
– DEF: the default value is 1 µs
– MIN: 1 µs
– MAX: 400 ms
Units are resolved to 1 ns.
1 µs to 0.4 seconds
DEF
MIN
MAX
:HOLD
Space
?
numeric_value
DEF
TRIG
:SEQ
MIN
MAX
NOTE
Trigger holdoff is not applicable when the power meter is set to power sweep
mode or frequency sweep mode.