OUTPut Subsystem 8
N1911A/1912A P-Series Power Meters Programming Guide 313
OUTPut:TRIGger[:STATe] <boolean>
This command enables or disables the trigger output signal.
When sensor is in triggered average measurement mode, the trigger output signal
will only be asserted after the measurement has settled.
Syntax
Example
Reset Condition
On reset, the trigger output signal is disabled.
This command is also applicable when used with 8480, N8480, E4410, E9300 or
E9320 sensor (Average mode only).
OUTP:TRIG:STAT 1 This command enables the trigger output
signal.
OUTP :STAT
:TRIG 0|OFF
1|ON
Space
?
To Next Page
Loading...
