17 IEEE 488.2 Command Reference
734 N1911A/1912A P-Series Power Meters Programming Guide
SCPI Compliance Information
This chapter contains information about the SCPI Common (*) Commands that the
power meter supports. It also describes the GPIB Universal Command statements
which form the nucleus of GPIB programming; they are understood by all
instruments in the network. When combined with programming language codes,
they provide all management and data communication instructions for the
system.
The IEEE-488.2 Common Command descriptions are listed below in alphabetical
order.
*CLS Clear Status page 735
*DDT and *DDT? Define Device Trigger page 736
*ESE and *ESE? Event Status Enable page 738
*ESR? Event Status Register page 740
*IDN? Identify page 741
*OPC and *OPC? Operation Complete page 742
*OPT? Options page 743
*RCL Recall page 744
*RST Reset page 745
*SAV Save page 746
*SRE and *SRE? Service Request Enable page 747
*STB? Status Byte page 749
*TRG Trigger page 751
*TST? Test page 752
*WAI Wait page 753
To Next Page
Loading...
