3 CALCulate Subsystem
182 N1911A/1912A P-Series Power Meters Programming Guide
CALCulate[1]|2|3|4:GAIN Commands
These commands are used to enter and enable a display offset on the specified
window/measurement. The display offset is applied to the measurement signal
after any math calculation.
The following commands are detailed in this section:
CALCulate[1]|2|3|4:GAIN[:MAGNitude] <numeric value>
CALCulate[1]|2|3|4:GAIN:STATe <boolean>
To Next Page
Loading...
