1 Power Meter Remote Operation
28 N1911A/1912A P-Series Power Meters Programming Guide
Introduction
This chapter describes the parameters which configure the power meter and help
you determine settings to optimize performance. It contains the following
sections:
– “Configuring the Remote Interface” on page 29.
– “Zeroing and Calibrating the P-Series Power Sensor” on page 32.
– “Making Measurement” on page 34.
– “Using Frequency Dependent Offset Tables” on page 50.
– “Setting the Range, Resolution and Averaging” on page 57.
– “Setting Offsets” on page 61.
– “Setting Measurement Limits” on page 63.
– “Getting the Best Speed Performance” on page 67.
– “How Measurements are Calculated” on page 72.
– “Status Reporting” on page 73.
– “Saving and Recalling Power Meter Configurations” on page 92.
– “Using Device Clear to Halt Measurements” on page 93.
– “An Introduction to the SCPI Language” on page 94.
– “SCPI Compliance Information” on page 103.
– “Summary of Commands” on page 105.
– “Making Measurements on Wireless Communication Standards” on page 106.
To Next Page
Loading...
