12 SYSTem Subsystem
546 N1911A/1912A P-Series Power Meters Programming Guide
CDMA2000
The cdma2000 set-up provides:
– Average power in a cdma2000 signal (bandwidth <=5 MHz).
– Peak power and peak-to-average ratio of the signal over a defined, statistically
valid number of samples. The reading is continuously refreshed. This indicates
how cdma2000 channel loading affects peak power and power distribution.
The measurement is a continuously gated measurement on a 3 GPP cdma2000
signal. Its aim is to measure the peak and average power corresponding to a
<0.01 % probability that there are no peaks above the returned peak reading. Time
gating is set to 10 ms, corresponding to 200,000 samples. Triggering is set to
occur continuously internally to the meter. The internal trigger is set to AutoLevel.
A reading over the 10 ms period is returned, then the reading is re-initiated for the
next 10ms period. In this way the reading always relates to a position beyond 0.01
% on the CCDF curve and will refresh to track any signal or DUT changes.
The following table shows the power meter presets when <character_data> is set
to CDMA2000. Commands not listed are preset according to their DEFault values
(for further information refer to Table 12-1):
Table 12-11 cdma2000: Power Meter Presets
Command Setting Comments
Frequency
[SENS[1]]|SENS2:FREQ[:CW|:FIX] +1900.000 MHz Frequency setting
Sensor measurement mode
[SENS[1]]|SENS2:DET:FUNC NORM Measurement mode
Sensor video bandwidth setup
[SENS[1]]|SENS2:BAND|BWID:VID E9321A/25A: DEF
E9322A/26A: DEF
E9323A/27A: OFF
N1921/2A: OFF
Sensor video bandwidth
Gate Setup
[SENS[1]]|SENS2:SWE[1]|2|3|4
:OFF:TIME
Gate 1: 0 s
Gates 2 - 4: 0
Delay between trigger point and time
gated period.
To Next Page
Loading...
Need help?
General
