10 SENSe Subsystem
390 N1911A/1912A P-Series Power Meters Programming Guide
[SENSe[1]]|SENSe2:BUFFer:MTYPe <string>
This command sets the measurement type to be returned from the buffer. It can
only be used in conjunction with external trigger.
Syntax
Parameters
This command is only applicable when connecting E9320 or N1920 sensor in
peak mode.
Item Description Range of Values
string The input measurement type to be fed to the specific input on the
SENSe block:
– PEAK: peak power
– PTAV: peak to average
–AVER: average
– MIN: minimum power
“PEAK”
“PTAV”
“AVER”
“MIN”
:MTYPe
Space
?
string
SENS
1
SENS2
FREQ
:
2
3
4
To Next Page
Loading...
