9 PSTatistic Subsystem
328 N1911A/1912A P-Series Power Meters Programming Guide
PSTatistic:CCDF:MARKer[1]|2:Y <numeric_value>
This command is used to set the current marker Y-axis position at the selected
trace.
Syntax
Parameter
[a] The marker will be placed at the point nearest to the specified Y-axis position if that particular Y value is not available.
This command is only applicable when P-Series sensors are present and the
following conditions are met:
– Free-run acquisition mode is selected
– NORMal or DOUBle measurement speed setting is chosen
PST
:CCDF
2
:Y
1
:MARK
Space
numeric_value
Item Description/Default Range of Values
numeric_value
The current marker Y-axis position
[a]
.
– Minimum Value: 0 %
– Maximum Value: 100 %
0 to 100
To Next Page
Loading...
