PSTatistic Subsystem 9
N1911A/1912A P-Series Power Meters Programming Guide 327
Example
Reset Condition
On reset, the marker 1 and marker 2 will be set back to their default positions.
Error Messages
– If command is executed in other window besides CCDF window, error –221
“Settings conflict: Requires CCDF window” occurs.
– If the requested X position is more than max dB then error –220 "Parameter
error" occurs.
– If invalid parameter choice has been used then error –224 “Illegal parameter
value” occurs.
PST:CCDF:MARK1:X 20 This command sets marker 1 to the position
where the X-axis is 20 dB.
To Next Page
Loading...
