SERVice Subsystem 15
N1911A/1912A P-Series Power Meters Programming Guide 703
SERVice:SENSor:CABLe:OPTion <numeric_value>
This command selects the sensor short cable option or long cable option.
Syntax
Parameters
Example
Reset Condition
On power up, the default setting is set to the short cable option. The selected
sensor cable option is not affected by SYST:PRES DEFault or *RST.
Query
SERV:SENS:CABL:OPT?
The query returns the selected sensor cable option.
Item Description/Default Range of Values
Numeric_value
A numeric value to indicate short or long cable options:
– 0: Sensor cable length ≤ 10 m (short cable)
– 1: Sensor cable length ≥ 10 m (long cable)
0 to 1
SERV:SENS:CABL:OPT 1 This command selects the long cable option.
:SENS
SERV
:CABL
Space
?
numeric_value
:OPT
To Next Page
Loading...
