Keysight N1911A

SYSTem Subsystem 12
N1911A/1912A P-Series Power Meters Programming Guide 497
SYSTem:COMMunicate:LAN:AIP[:STATe] <boolean>
This command enables the AutoIP protocol to dynamically assign the IP address
when connecting to the power meter in an isolated (non-site) LAN network (for
example, laptop to power meter).
Syntax
Example
Query
SYSTem:COMMunicate:LAN:AIP?
– 1 is returned if AutoIP is enabled
– 0 is returned if AutoIP is disabled
Query Example
SYST:COMM:LAN:AIP ON This command enables the AutoIP
SYST
:COMM
:LAN
:AIP
:STAT
0|OFF
1|ON
Space
?
SYST:COMM:LAN:AIP?
This command queries the state of the
AutoIP.