MEMory Subsystem 7
N1911A/1912A P-Series Power Meters Programming Guide 279
MEMory:CLEar:TABLe
This command is used to clear the contents of the table currently selected using
MEMory:TABLe:SELect. Although the table remains, a
MEMory:TABLe:FREQuency|GAIN:POINts? query returns a 0 as the table contents
are empty.
This command is an alternative form of the MEMory:CLEar[:NAME] command. The
difference is the method in which the table is selected.
Syntax
Example
Error Message
If no table is selected, error –221, “Settings conflict” occurs.
The contents cleared using this command are non-recoverable.
MEM:CLE:TABL This command clears the contents of the
currently selected table.
To Next Page
Loading...
