Keysight N1911A

SYSTem Subsystem 12
N1911A/1912A P-Series Power Meters Programming Guide 501
SYSTem:COMMunicate:LAN:CURRent:SMASk?
This command returns the current setting of the LAN subnet mask in use by the
power meter.
Syntax
Example
NOTE
If DHCP or AutoIP are successfully enabled, then one of these IP address modes
assign the LAN subnet mask, otherwise it is the static LAN subnet mask.
SYST
:COMM
:CURR
:SMAS
?
:LAN
SYST:COMM:LAN:CURR:SMAS? This command queries the current setting of
the LAN subnet mask.