Keysight N1911A

13 TRACe Subsystem
634 N1911A/1912A P-Series Power Meters Programming Guide
TRACe[1]|2:STATe <boolean>
This command enables or disables trace capture for the specified channel.
Syntax
Example
Reset Condition
On reset trace capture is set to OFF.
Query
TRACe[1]|2:STATe?
The query command enters a 1 or 0 into the output buffer indicating whether or
not trace capture is enabled or disabled.
– 1 is returned when trace capture is enabled
– 0 is returned when trace capture is disabled
NOTE
This command does not allow the setting set to ON when either measurement
channel (for dual channel) is configured to initiate trigger buffering.
TRAC
0|OFF
1|ON
Space
?
:STAT
1
2
TRAC2:STAT 1 This command enables trace capture for
Channel B.