TRACe Subsystem 13
N1911A/1912A P-Series Power Meters Programming Guide 635
Query Example
Error Messages
– If a P-Series or E-Series E9320 sensor is not connected, error –241, “Hardware
missing” occurs.
– If an E-Series E9320 sensor is connected and set to AVERage mode rather than
NORMal mode, error –221, “Settings conflict” occurs.
– If source is set to ON ( for dual channel, at either measurement channel) when
the N1920 sensor is connected in normal mode and SENse:BUFFer:COUNt or
SENse:FREQuency:STEP is more than 1, error –221, “Settings conflict”
occurs.
TRAC1:STAT? This command queries the current state
of trace capture for Channel A.
To Next Page
Loading...
