10 SENSe Subsystem
406 N1911A/1912A P-Series Power Meters Programming Guide
Query Example
Error Messages
–If [SENSe[1]]|SENSe2:CORRection:DCYCle:STATus is set to ON while
[SENSe[1]]|SENSe2:SPEed is set to 200, the error –221, “Settings Conflict”
occurs.
– If this command is used when an E4412A/E4413A power sensor is connected,
the error –310, “System error;Dty Cyc may impair accuracy with ECP sensor”
occurs. If you are using a dual channel power meter the error message
specifies the channel.
– If this command is used when a E9320 power sensor is set to NORMal mode,
the error –221, “Settings Conflict” occurs.
– If this command is used when a P-Series power sensor is connected, the error
–241, “Settings Conflict” occurs.
CORR:GAIN3:STAT? This command queries whether the pulse
measurement feature is on or off.
To Next Page
Loading...
