N1911A/1912A P-Series Power Meters
Programming Guide
27
1 Power Meter Remote
Operation
Introduction 28
Configuring the Remote Interface 29
Zeroing and Calibrating the P-Series Power Sensor 32
Making Measurement 34
Using Frequency Dependent Offset Tables 50
Setting the Range, Resolution and Averaging 57
Range 60
Configuring the Remote Interface 29
Setting Offsets 61
Setting Measurement Limits 63
Getting the Best Speed Performance 67
How Measurements are Calculated 72
Status Reporting 73
Saving and Recalling Power Meter Configurations 92
Using Device Clear to Halt Measurements 93
An Introduction to the SCPI Language 94
SCPI Compliance Information 103
Summary of Commands 105
Making Measurements on Wireless Communication Standards 106
This chapter describes the parameters that configure the power meter and helps
you determine settings to optimize performance.
To Next Page
Loading...
