2 MEASurement Commands
160 N1911A/1912A P-Series Power Meters Programming Guide
Example
Error Messages
– INITiate:CONTinuous must be set to OFF on both channels, otherwise error
–213, “INIT ignored” occurs.
–If TRIGger:SOURce is set to BUS or HOLD on either channel, error –214, “Trigger
deadlock” occurs.
– If the resolution parameter is not the same as the current resolution setting on
the specified window, error –221, “Settings conflict” occurs.
READ:RAT:REL? This command queries the relative ratio
measurement on the upper window/upper
measurement.
To Next Page
Loading...
