3 CALCulate Subsystem
208 N1911A/1912A P-Series Power Meters Programming Guide
Example
Query
CALCulate[1]|2|3|4:RELative[:MAGNitude]:AUTO?
The query always returns OFF.
Error Message
–If CALCulate:RELative[:MAGNitude]:AUTO is set to ONCE while SENSe:SPEed is
set to 200, error –221, “Settings Conflict” occurs.
– If the value is set to ON error –224, “Illegal parameter value” occurs.
CALC1:REL:AUTO ONCE This command sets a reference value to be
used in the relative measurement on the
upper window/upper measurement.
To Next Page
Loading...
