4 CALibration Subsystem
224 N1911A/1912A P-Series Power Meters Programming Guide
Example
Reset Condition
On reset, the reference calibration factor is set to 100 %.
Query
CALibration[1]|2:RCFactor? [MIN|MAX]
The query returns the current setting of the reference calibration factor or the
values associated with MIN and MAX.
Query Example
Error Messages
If this command is used when a P-Series, E-Series or N8480 Series power sensors
(excluding Option CFT) is connected the error –241, “Hardware missing” occurs.
CAL1:RCF 98 This command enters a reference calibration
factor of 98 % to Channel A.
CAL2:RCF? This command queries the reference
calibration factor of Channel B.
To Next Page
Loading...
