5 DISPlay Subsystem
238 N1911A/1912A P-Series Power Meters Programming Guide
Reset Condition
On reset, the value is set to –70 dBm for both windows.
Query
DISPlay:[WINDow[1]|2]:ANALog:LOW? [MIN|MAX]
The query returns the current setting of the analog meter’s lower scale limit, or the
value associated with MIN or MAX. The format of the response is <NR3>. The units in
which the results are returned are determined by the current setting of
UNIT:POWer and CALCulate:RELative:STATe as shown in Table 5-1.
Query Example
DISP:WIND1:ANAL:LOW? This command queries the lower scale limit
set on the analog meter in the upper window.
To Next Page
Loading...
