DISPlay Subsystem 5
N1911A/1912A P-Series Power Meters Programming Guide 253
Example
Reset Condition
On reset, the resolution is set to 3.
Query
DISPlay[:WINDow[1]|2]:RESolution? [MIN|MAX]
The query returns the current setting of the window’s resolution or the value
associated with MIN and MAX. The format of the response is <NR1>.
Query Example
DISP:WIND2:RES 4 This command sets the lower window’s
resolution to four significant digits if the
measurement result is linear, or to 0.001 if
the measurement result is logarithmic.
DISP:WINDow1:NUMber2RES? This command queries the resolution setting
of the upper window/lower measurement.
To Next Page
Loading...
