9 PSTatistic Subsystem
340 N1911A/1912A P-Series Power Meters Programming Guide
Query
PStatistic[1]|2:CCDF CONTinuous?
The query enters 1 or 0 into the output buffer indicating the status of the CCDF
Continuous Refresh mode.
– 1 is returned when the CCDF Continuous Refresh mode is enabled
– 0 is returned when the CCDF Continuous Refresh mode is disabled (or CCDF
Single Refresh mode is enabled)
Query Example
Error Messages
– If no sensor or wrong sensor is connected to the channel, error –241
"Hardware missing" occurs.
– If channel is not in free-run acquisition mode, error –221 "Settings conflict"
occurs.
PST1:CCDF:CONT? This command queries whether the CCDF
Continuous Refresh mode is on or off for
Channel A.
To Next Page
Loading...
