10 SENSe Subsystem
372 N1911A/1912A P-Series Power Meters Programming Guide
Query Example
Error Messages
If a filter length value is entered using [SENSe[1]]|SENSe2:AVERage:COUNt while
[SENSe[1]]|SENSe2:SPEed is set to 200, the error –221, “Settings Conflict”
occurs. However, the filter length value is set but the
[SENSe[1]]|SENSe2:AVERage:STATe command is not automatically set ON.
AVER:COUN? This command queries the filter length for
Channel A.
To Next Page
Loading...
