10 SENSe Subsystem
382 N1911A/1912A P-Series Power Meters Programming Guide
Reset Condition
On reset, the filter length is set to 4.
Query
AVERage2:COUNt?
The query returns the current setting of the video filter length. The format of the
response is <NR1>.
Query Example
Error Messages
– If the command is used when a sensor other than a P-Series or E9320 power
sensor is connected, error –241, “Hardware missing” occurs
– If the command is used when an E9320 sensor is connected and set to
AVERage mode rather than NORMal mode, the error –221, “Settings Conflict”
occurs.
AVER2:COUN? This command queries the video filter length
for Channel A.
To Next Page
Loading...
