SENSe Subsystem 10
N1911A/1912A P-Series Power Meters Programming Guide 387
Error Messages
– If the command is used when a sensor other than a P-Series or E9320 power
sensor is connected, error –241, “Hardware missing” occurs
– If the command is used when a P-Series or an E9320 sensor is connected and
set to AVERage mode rather than NORMal mode, the error –221, “Settings
Conflict” occurs.
Selection of video bandwidth to LOW, MED or HIGH implements digital signal
processing to ensure a flat bandwidth up to the frequency shown, bandwidths
are flat to ±0.1 dB. In the OFF state no corrections are applied and the response
has a slow roll-off.
To Next Page
Loading...
